My iphone case
February 21st, 2007 at 3:49 PM by Dieter
I made this case for the iphone and it should actually be feasible to manufacture which is always good when your designing something. I made the top cover so it is a super thin touch sensitive layer of plastic so the screen can be used with the front case on. The only thing is that I kinda forgot to make some holes for the microphone on the bottom so people can hear you talking but maybe the hole I made for the dock connector is good enough.
3 days, 23 hours later
Don’t forget there’s a proximity sensor in there. You’re probably fine as long as you left a hole for the speaker; I think the sensor is in there. What is the material that is touch sensitive?
4 days, 5 hours later
I was figuring it could just be really thin plastic, like some of the ipod cases that have been made already with covers over the click wheel. I don’t know if that would be good enough for the precision needed.